POD Smart Pod Steamer 2
STEAMERPOD2
- Multi-purpose 110v steamer great for wrap prep and cleaning as well as wrap removal and de-badging.
- Designed for use with all types of vehicle graphics, wraps, transit, reflective, sign, PPF, as well as film removal and de-badging
- Includes 11 different heads designed for different applications, removals, cleaning, and even detailing every inch of a vehicle.
- Pressurized steam is hot enough to apply films but does not harm vehicle or installer
- Great to pre-heat and post-heat vehicle wraps
- 9 foot hose
- Auto Shut-off if unit gets too hot
- 110V
- Use Distilled Water Only!
- Dimensions: 20” x 13” x 13” Weight: 18lbs (empty)
USE DISTILLED WATER ONLY
Do Not Overfill – Do Not Run Dry
Do not direct steam at people, animals or at electrical devices.
Do not operate machine without Distilled Water in the tank.
Always purge machine (depress trigger and hold for 3 seconds) before use and after idle
for 3-minutes or more.
Do not allow machine to run unattended at any time.
Close supervision is necessary when this machine is used near children. Do not allow it
to be used as a toy.
The machine is designed for TRAINED PERSONEL only, do not expose to rain.
Do not overfill the water tank. The machine contains a maximum of 1500ml of Distilled
Water only. Overfilling of the water tank may cause damage or injury.
Never turn the machine over or tilt more than 45 degrees when it is switched on or if it’s
still producing steam.
Never use this machine to clean electronic devices or installed electronics.
Do not run UNIT for more than 1 hour at a time.
Use extra care when cleaning on Dash Boards. Some dashboards cannot be exposed to
moisture whatsoever.
Do not immerse cord, plug or machine in water or any other liquid.
Do not operate with a damaged cord, if the power cord is damaged or any improper
performance of this machine occurs it should be repaired by a qualified electrician only.
Keep hair, loose clothing, fingers, feet and all parts of body away from the jet of steam.
Do not operate machine in bare feet or when wearing open toe shoes or sandals.
Do not pull or carry by cord, use cord as a handle, close door on cord or pull cord around
sharp edges or corners. Keep cord away from heated surfaces.
Unplug steamer when not in use. Turn all controls off before unplugging from outlet.
Do not unplug by pulling on cord. Always grasp the plug, not the cord. Never handle
plug or appliance with wet hands.
Store in a dry place. Do not expose machine to freezing temperatures.
Do not try to repair the Pressure On Demand Steamer unit yourself. Contact a qualified
technician. To avoid danger, a defective cable should be replaced only with an equivalent
cable and by the manufacturer, our after sales service or someone with a similar
qualification.
Use only original accessories.
Regularly check the appliance and the cable. Do not switch the appliance on if it is
damaged.
STEAMERPOD2